SparkFun Breakout Board for VS1000 (BOB-08849)

Further infos: SparkFun Breakout Board for VS1000D

Software:
How to flash the Firmware:
  1. Remove all connections from the Breakout Board.
  2. Set CS1 to low: Add a wire from GND to R5 (100k):
  3. Connect the Board to the PC via USB and press the Power button on the Board.
  4. Check the new drive. There should be only one file: NO_FLASH.
  5. Run VS1000D-Tool (vs1000d.exe)
  6. Make the following settings and press USB Search:
          Nominal Size: 256 MByte
      Block Size:   128 kByte
      Page Size:      2 kByte
  7. Select VS1000D -> Upload USB boot file and choose VS1000_B.RUN
  8. Copy the file boot.img to the new drive with the Windows Explorer.
  9. Select VS1000D -> USB Boot
  10. Remove the USB connection from the Board.
  11. Remove the short-circuit between CS1 and GND
  12. Now you can control the Board via Rx/Tx (UART).
          Baud rate: 115200
      Data:      8
      Stop:      1
      Parity:    None
      Voltage:   3.3V
    13. 
  
  13. The commands can be found in uartcontrol.txt.
    14.